Ok, so I have just got done searching but still have found no answer to my two questions.

1. What color code have you all used to match your aftermarked a-pillars to the rest of your pillars (I have an 03 evo GSR)

2. I know its a dumb question... but how do you get the a-pillar off? Looks like its just held in with snaps but I don't want to start pulling untill I have some feedback.

Thanks in advance guys!

 

I know Sleet did a nice how-to for this..Check in the how to for a stealth interior..or gimme a min and i will find it.

Here ya go man hope this is what you were asking for

 

Thanks I-Dom-In-8!
Thats a great write up, It is exactly what I needed for removal of the a-piller but I would like to retain the stock color. Any suggestions?

 

When I painted mine I went and grabbed the only gray duplicolor interior paint they had and it is slightly darker, however is not noticeable. Let me know if you want the exact color and pics and Ill dig them up.

 

lancershop.com sells one already painted to match the enterior and if I remember right it was only like 60 bucks for the dual gauge piller

 

if you could that would be great. I already have my gauge pod and its black... I know almost nothing will be perfect but I don't want people to get in and notice right away.

 

and i heard the lancershop one doesn't match for ISH

 

I used VHT plastic paint, light satin grey (SP-971). It matches very close but not perfect. I just painted the single a-pillar pod... but it would look perfect if you painted the entire pillar.

Couple pics:

 

perfect thanks Mrich!

 

I used a krylon gray, it matched pretty close, and I sprayed both pillars to make sure they were a match. Did it about 2 years ago and they still looks great!!!