I do not want to run it that high.
I meant high for a daily driven with the mods I have and the gas I use.

 

Ordering within the 30mins
GSC Evo IX S1 Cams
Walbro 255 fuel pump kit
Forge UNOS MBC
Tatrix Cable for Mellon Tune
and
Getting a used Megan Racing Header for free from a friend (upgraded his turbo) and going to coat it. =D

Anyone have any comments before I send my order in? =D Im excited

 

Looks good to me.

Don't install the header - just sell it and port/coat your stocker.

 

What is wrong with the megan?

 

lol. now if i can find companies that take different billing and shipping lol

 

What's wrong with the Megan? Ahhhhhhhhhhhh, this thread is my worst nightmare. Please, please, please, would you do a search on _EVERY_ mod you plan to do? This stuff is common knowledge to most, but you don't know the basics even. The Megan is known to crack easily, and it doesn't make as much power as porting the stocker anyway.

 

oh.

 

hey warr im looking at my credit card profile it has address 1 then below is address 2 is that a secondary address to resolve shipping and billing issues?

 

so are those gsc s1, 265i 272e camshafts ?

 

I'm sorry, but I have to disagree with the statement in regards to the Megan headers. I've heard all sorts of rumors, but haven't actually met anyone with issues, on the other hand, I've been running my Meagn headers for over a year now with no issues and have personally spoken with several people who have had good results. I had a dyno sheet that I posted several months back showing a gain of 17 hp, I can't remember the TQ, but it was good & it came in down low too.
So based on my own firsthand experience with 25 track sessions in the south FL. heat, multiple runs on The Dragon,Deals Gap, all done in "***** out' mode, not to mention aggressive street driving(about 12-15000 miles since installed), I highly recommend them

 

+1 and there's to much to go wrong with electronics.

 

My megan cracked. My car started ticking after a few months and I was wondering what it was. Changed to a ported header and the ticking was gone. Looked on the welds of the megan and there were cracks.

But hey if it free go for it. You should do the installation dont wanna waste money for something that will probly be swapped out in a few months