06 Evo MR and TBE?
with the exhaust and the ground? it's a decent bit of clearence. i would say maybe 8 - 10 inches at the lowest part of exhaust? somewhere in there.
i have a ix mr with invidia 3" SS downpipe, perring HFC, and HKS carbon Ti cat-back. no ground scraping issues, and she is lowered on works ride springs by about an inch. occasionally if i am pulling over a steep curb i will scrape a little, but nothing major.
most of the clearence issues with the ix mr deal with the downpipe clearing the transfer case, or the cat clearing the center differential. once in a while my DP will rattle a bit off the tcase, but that is in frequent and it's not that severe when it does happen.
here are a couple pics from under the car.


at that point the nose of the car was still up on ramps too.
i have a ix mr with invidia 3" SS downpipe, perring HFC, and HKS carbon Ti cat-back. no ground scraping issues, and she is lowered on works ride springs by about an inch. occasionally if i am pulling over a steep curb i will scrape a little, but nothing major.
most of the clearence issues with the ix mr deal with the downpipe clearing the transfer case, or the cat clearing the center differential. once in a while my DP will rattle a bit off the tcase, but that is in frequent and it's not that severe when it does happen.
here are a couple pics from under the car.


at that point the nose of the car was still up on ramps too.
Last edited by MondoBongo; Nov 9, 2007 at 09:54 AM.
Trending Topics
i found a pic on this thread
https://www.evolutionm.net/forums/sh...ht=TBE+exhaust
https://www.evolutionm.net/forums/sh...ht=TBE+exhaust


