Got my tail whooped.

Replaced the discharge hose so I can have cold air again.
Replaced leaking LF axle seal.
Replaced timing belts since I had new timing covers to install anyway.
Found drivers lower ball joint pinch bolt was beat to death, half the threads missing, and stacked with washers so that the nut would contact what threads were left. Awesome.
Couldn't torque the drive belt idler beyond 15 ft lbs, threads jacked up. Couldn't adequately clean them (helped to 20 ft lbs), drilled out the boss and put a helicoil in, managed to get 40 ft lbs out of it... doused it with loctite and called it good enough and came home for the night.

 

Replaced my HVAC gears with the revised set. Checked all balljoints up front in an effort to find my low speed clunk. Found huge threads on low speed clunk on here. Datalogged and confirmed that the reason my 2byte load didn't work is because I'm an idiot and changed the formula in EvoScan.

 

Buffed and waxed then installed new badges

 

Found an oil leak.

Found out that my oil line (definitely) and turbo (maybe) are aftermarket.

: confused:

 

Today I replaced the driver front hub. Noise I was hearing is still present now I feel like an idiot as I have a sneaking suspicion that what I'm hearing is instead tire noise

 

I was in a bad mood cause of my Gf so I took it out and beat all 524 horses out of it. I also embarrassed a M5. Happy easter to me :-/

 

Send me a pic of ur Turbo with the intake off and the hotside of where ur o2 housing comes off of it.

 

looked at it again, just waiting for my base map so I can start it for the first time in 3 months to make sure it even works...

 

Installed my single ETS catback exhaust yesterday! Happy girl.

 

Ordered a new drivers side mirror because some punk kid broke mine

 

are you the one that made the thread about following them out into the street and calling the cops? or was that some Canadian hockey player...?

 

Is this You Lang? Did u post about this on wiscoevo?

 

LOL.!!!

stupid question but what does it take to become an Evolved member on here?

 

That bottom pic looks sick. Seriously bad ****. Even tho I'm more of an Evo 8/9 guy myself. And Yes it's bias cause I own one but I think the booty on this X looks nasty.

 

After gaining a few more scars and bruises to myself, I installed a driver's side (RHD) rear hub with new wheel bearing and the damn noise is still there. Passenger side begins tomorrow.

500 useful posts.