so, i had kelford 272's installed a few months ago, everything seemed to have went well until a week later when my SES light came on. the code P0365 came up as camshaft position sensor cuircut B. so i checked the intake cam sensor(MIVEC) and it was broken in half. i went to the dealership, and I installed the new one. the code WILL CLEAR on the first start but comes back on the second. timing and everything has been checked, triggers etc. but, when the sensor is unplugged the car still runs, but if the exhaust sensor is pulled, its does not start. is that supposed to happen??? cams do not lope really. can anyone please help me out?

 

anyone?? help??

 

Sorry to bring back an old thread but BUMP...

I recently installed Kelford 272's on my IX. Then P0365 came on. The intake CAS was cracked so I bought a new one. When I clear the code it goes off. I can drive the car for 10 miles, but once I turn it off it and turn it back on, the CEL lights up immediately.

Would having the car flashed back to stock work, just to pass emissions? In CT you cannot have a single CEL or you will fail.

 

I still have the code till this day. im about to install my stock cams.