Saw this under the car tonight, anyone know where it goes to/from? ABS sensor?

 

yes

 

Im going to pull off the wheel tonight then, where is the sensor located that it goes to?

 

Flux capacitor lead wire. You won't need it unless you go over 88mph... But, yes it is the ABS wire.

 

Check the other front hub. You will see where the wire goes and how it is mounted.

 

there is a hole on the knuckle, right on top. the sensor is held down with a 10mm bolt. that's where it reads the ABS ring on the axle.

 

So...the damn speed sensor is rusted solid into the wheel hub. Any suggestions for getting out out? :/

I already tried PB Blaster, hammering it from the back and a pry bar from the front.

 

Maybe try a little bit of heat?

 

speed sensor aside, ide be more concerned with all that rust!

 

you mean the bolt? easy-out or a drill :-(

 

just in general, that seems like alot of rust. Im on the west coast though, so what do i know...

 

Tried heat but no luck. Looks like Im pulling the arm off to either drill or press it :/

No ****, Im in AZ so the cars here have dry seals and rubber but never any serious rust. This thing came from the east coast so its a whole different ballgame.

 

Heat will make it expand and just make it harder to get out. Try this, get a can of compressed air and turn it upside and freeze the hell out of it while keeping the hub part warm.