I'm trying to change my right front steering knuckle on my evo ix mr, it's already lose the only thing I wasn't able to take or or know how to take off is the brake line that is connected to the steering knuckle I know is a especial tool but I don't know whats the name of the tool!!

 

You have a pic? Only thing I've used to take off brake line is wrenches and pliers to pull off clips holding brake line in place

 

So I think is the sensor from tha abs did you know how to remove it with out braking it??

 

Yes that looks like a bitoch. Not sure what tool is needed for that :/

 

Try this man https://www.evolutionm.net/forums/ev...r-removal.html

 

Yeah I know but thanx anyway! !!

 

K sweet bro thanx!!!

 

Good luck getting that bastard outta there. My driver side knuckle got bent a couple years back from a Chicago pothole so no one could get the alignment correct because of the bent knuckle. I had to swap my knuckle out myself on the driver side and I really feel like removing that sensor without damaging it is nearly impossible. The worst part is a new one is like $300 or some crazy ish. I finally got frustrated and pulled a little too hard and snapped the sensor in half. Haha luckily TAE auto in Florida sold me a used one for $60 and I threw that in the new knuckle and I was good to go. If you do happen to damage the sensor removing it again you can get one pretty cheap used from TAE. Good luck man.