I just installed my LICP I bought from Maperformance. It doesn't seem to fit properly since the pipe section near intercooler is touching the front bumper and preventing proper fitment of bumper. I even removed the oil cooler air passage plastic trim and it still touches bumper. I just removed the stock LICP piping and fit on the aftermarket one.

Am I doing something wrong or forgetting a step to make it fit correctly?

Thanks. My car is 2004 Evo.

 

loosen all your clamps and adjust as needed until you get the rt angles and the bumper doesnt touch, likely you have to adjust a couple of sections to improve just on area.. good luck

 

Yup. You may need to rotate the piping a bit until you find its sweet spot. The licp isn't so bad, but my short route uicp I had to readjust a few times until it all lined up.

 

leave everything loose and get it where it fits best then tighten the clamps. check for boost leaks while you have the bumper off