So far I have all of the bolts removed holding the holder to the bumper. Removing that ****ing one screw is kicking my ***. It will not unscrew ! It turns when I turn it but thats all its doing (Yes I know righty tighty and lefty losey). Has any one else had this problem removing the holder.

 

If I remember correctly, that one screw you may be having trouble with is really just held in place with a rubber grommet. Therefore, you might have to get behind the bumper with a finger or something to stop the grommet from spinning in the bumper while you unscrew it.

Hope that is it.

 

Thats exactly what the problem is. Thanks... Now I just have to figure out how to stop it from spining. The finger thing isn't working...

 

Moving to Evo HT/ Questions.

 

on my car that piece\bolt you refer to was just a piece of large Vac line on a Phillips screw with no bolt or washer on the end, i was able to gently wiggle mine out with no tools but my fingers (needle nose lockgrips would be nice tho!)

 

You were able to wiggle the screw out or the hole rubber piece w/ the screw?