How TO: release throw out bearing
Mar 11, 2008, 12:23 AM
#1
Account Disabled
Thread Starter
iTrader: (28)
Join Date: Jul 2006
Location: ft. walton beach, FLORIDA
Posts: 1,115
Likes: 0
Received 0 Likes
on
0 Posts
How TO: release throw out bearing
Well since it seems like alot of evo owners have problems with this i figured i would try to help a little.
All of this will be done through the inspection hole in the tranny, i just did it out of the car to you could see it alot better. Make sure you do this before you unbolt the bell housing
Take a flat head and stick it in between the TOB and wedge collar.
Use the clutch fork to move the TOB toward the pressure plate.
While the TOB is against the pressure plate turn the flat head, while the flat head is sideways push the clutch fork so it makes the TOB slide away from the pressure plate.
well, thats all there is to it. I hope i helped some of you that havnt done an evo clutch yet.
-nick
All of this will be done through the inspection hole in the tranny, i just did it out of the car to you could see it alot better. Make sure you do this before you unbolt the bell housing
Take a flat head and stick it in between the TOB and wedge collar.
Use the clutch fork to move the TOB toward the pressure plate.
While the TOB is against the pressure plate turn the flat head, while the flat head is sideways push the clutch fork so it makes the TOB slide away from the pressure plate.
well, thats all there is to it. I hope i helped some of you that havnt done an evo clutch yet.
-nick
Last edited by Dapper Dan; Jun 5, 2008 at 12:15 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Dapper Dan
Evo Show / Shine
15
Jan 14, 2008 12:53 PM
