nice write-up
Thats a very cool little mod. (no pun intended, )

Have you been able to test it out and see how much the temp dropped?
And how is the current draw on that fan, is it minimal?

here is the spec of the fan:


http://www.spalusa.com/pdf/30103013_SPEC.PDF#view=FitH

the fan itself:

http://www.spalusa.com/store/main.as...&item=30103059

nice write up

thanks!

awesome! what is normal operating temp as compared to after the fan install? mine never operates below 190*

it hasn't gotten too hot here lately and just installed it this afternoon. will find out in the next few weeks. after I turned it on the temp needle dropped a few marks, not bad. I just hope that my right front tire doesn't get heat soaked

Please keep us updated on this post, when you get some time to see how it works..

def. a cool mod..

Well done!

Sticky worthy!

thats a pretty cool idea, one for the todo list!

sweetness good write up tell us how it performs when the heat comes

after a hot lap in the autox where temps went up to 80-85C, turning on the cooler fan lowered it to 70C in no time. wished the times went down too

bigger fan? jk

thats quite a difference in temp very cool

Can't quite see the brand, part number, etc., Where did you buy this? I'm getting ready to install my fan also, just want to know about this connector, so I can do a clean install.

BTW, awesome job on this DIY thread!

Just pm'ed ya, but I got it from a regular parts store(bumper to bumper) and just stumbled on it. it is a universal connector made by motormite(?). part # should be in the pm.

Hey sblvro.... I wanted to give this setup a try also. But I was not able to find a connector like you did. Could you pm me the part number also....


Thx