I just installed my rebuilt tranny and my throughout bearing isnt engaging. everything seems to be correct. Is there a certain way to have it engage with the clutch?

 

found the problem! the wave spring and metal ring that is attached to the pressure plate fell off while fitting the tranny. time to do it over. great!!!!

 

dont even remind me about the TOB....omg omg omg

 

o the tob

 

Tell me about it I put the CC stage 4 clutch in and just dropped the tranny. It all went good got the tranny in first try moved the fork and the TOB popped into place. Put everything back back filled all new fluids drove the car for about 1.2 mi and it popped out. Drove back home in 1st gear got pissed off and dropped the whole motor which was a little easier. Now up to 540mi on new clutch and seems fine

 

And all this took about a week and half... Working from 7-7 then coming home and working on car from 8-1am

 

Yes, it happened to me too when I installed the trans. F*cking ring, I heard it pop off when installed. Best thing to do is watch carefully when installing and try to move the clutch after bolting up to make sure it's all good.

 

the Fuc**** TOB...i did the same thing the first time i did my clutch popped the ring out and had to drop it all over again the next day...and now my TOB is making noise when not engaged so im pretty sure im gunna have to do it all over again soon