i have a perrin tb exhaust, will i have any problem getting the bumper on without cutting the exhaust? i know people are cutting the exhaust to make it look better but will fit if i dont?

im asking because im getting a new tbe and was going to have it pre-cut an 1" behind the muffler and i was going to sell the perrin tbe but i wasnt going to do this for a few months so i need to rock the perrin exhaust non cut with the jdm bumper should i run into any problems?

 

think the fitment is ok. just the muffler sticks out silly far

 

https://www.evolutionm.net/forums/ev...in#post5311928

Post #2 in this has a list of exhaust that need modifying to properly fit the bumper. seems like people have had to take a few inches off the perrin catback rear section...

 

oh crap, thanks

 

Man I want a jdm rear bumper were can I get one cheap?

 

there not cheap unless you want a knock off

 

As long as the knock off looks legit with decent fitment...I'm game

 

I have a Cobb exhast (not that you can get them anymore), but they had built one specifically for the NA buper and one for JDA. The JDA was shorter and therefore I assume many other TBE's/CatBack's will be the same.

 

Dont get a knockoff because it will most likely come in fiberglass and fiberglass sucks imo

 

Get oem