Anyone have a how to with installing the perrin intake? i am just trying to figure out the mounting of the shield and everything

 

it did not come with instructions? you just mount the shield on the same holes you took the stock intake from. if you would like some installed pics, just message me.

 

It came with some skimpy ones haha im asking cause... welll i never had a stock intake i donno how it was lol

 

It can be a PITA. It took me a while but I ended up shortening the intake to make sure my filter would clear the acd fluid resivior. I used self-tappers to mount the shield.

 

check the website or instructions.

it uses a bolt that is already there to bolt the shield to the frame rail.

 

yeah i figured it out but i gotta clean out my maf and 1 of the two bolts that holds the shield in is broken :/ but i cant get the shield to go through the maf part. the 4 threads that hold it on dont line up right

 

post a pic of how its not lining up. It took me a few minutes to figure it out and line everything up right.

 

sometimes they can be a pain- especially if you have another upper intercooler pipe-

but it will fit-

cb

 

 

there is always 1 corner i cant get to line up

 

I remember having the same issue, I think i had just bent or twisted one of the pieces just a hair ro line it up. Im going out in a few I will take a good look at mine. See if I can help.

 

Sorry to steal the thread but has anyone shortened the intake tube and drilled new holes to make more room?

 

read my post above. Yes.

 

Over looked that post. Do you have any pics?

 

No, but all I did was took about an inch off before the maf. It fits much better without the filter touching anything. I also took some of the wire harness clips off and routed the harness around the right side of the acd fluid.