hello im currently in the process of having a LED cluster made for my Evo 8. but i can not find a schematic any where that has what each pin for the cluster does and the specific parameters for them. was wondering if anyone had any info on this?

 

C-106 (White Connector)

1 BLK...........Ground 3
2 BLK...........Ground 3
3 BLU/GRN.......Left Turn Signal (+)
4 RED/WHT.......High Beam (+)
5 BLK...........High Beam (-)
6
7 RED/BLK.......J/C 1 (+) (10AMP FUSED)
8 YEL...........Door (+)
----------------------------------------
Ignition
9 YEL/RED.......Charge (+)
----------------------------------------
10 GRN/WHT......Tarmac (-)
11 GRN..........ECU/Tach Input
12 WHT/BLK......Speedometer Input
13 GRN/ORG......ABS
14 PNK..........Gravel (-)
15 VLT..........Snow (-)
16
17 WHT/BLU......Check Engine (-)
18 WHT..........Oil (-)
19 RED..........Charge (-)
20 BLU..........Fog (+)
21

C-108 (Blue Connector)

31
32 BRN..........Brake (-)
33 VLT..........Water Spray (-)
34 BLU..........Door (-)
35 RED..........Seat Belt (-)
36 GRN/YEL......Air Bag (-)
37 BLU/GRN......Brake (+)
----------------------------------------
Positive Lead
38 GRY..........General (+)
----------------------------------------
39
----------------------------------------
Negative Lead/Rheostat
40 BLK/YEL......J/C 3 (-)
----------------------------------------
41
42
43
44
45
46
47
48 BLK..........(-)
Fog (-)
Turn Signal (-)
49 PNK..........Right Turn Signal (+)
50 YEL..........Water Temp Input
51 GRN..........Fuel Gauge Input


Fog Light Switch
1
2
3 - Black Yellow - From Rheostat
4 - Green White + From fuse box 7.5a

Hazard Warning Light Switch
1
2
3 - Green White + From fuse box 7.5a
4 - Black Yellow - From Rheostat

 

 

That I can't tell you. I'm assuming 12V across the board. Just measure the connector with a volt meter, wouldn't take long at all. The cluster comes out in 3min.