Make you front sway bar adjustable.
Thread Starter
Evolving Member
Joined: Sep 2003
Posts: 124
Likes: 1
From: Modesto.Ca
Make you front sway bar adjustable.
Jack up the car and remove the wheels, place jack stands under the lower control arms.
Remove the tie rod end from the spindle. Undo the end links. Using a 27/34”drill bit I drilled center-to-center ¾”. The sway bar mounting tabs are an inch thick. You will need to mark ½” down to center. Place a two by four under the sway bar. Drill…drill and drill. This may take some time. The sway bar is made out of hard spring steel. When the hole is done you can put it all together.
http://www.we-todd-did-racing.com/we...MXk1NDE%3D.jpg
http://www.we-todd-did-racing.com/we...MXk1NDE%3D.jpg
http://www.we-todd-did-racing.com/we...MXk1NDE%3D.jpg
http://www.we-todd-did-racing.com/we...MXk1NDE%3D.jpg
http://www.we-todd-did-racing.com/we...MXk1NDE%3D.jpg
http://www.we-todd-did-racing.com/we...MXk1NDE%3D.jpg
http://www.we-todd-did-racing.com/we...MXk1NDE%3D.jpg
Remove the tie rod end from the spindle. Undo the end links. Using a 27/34”drill bit I drilled center-to-center ¾”. The sway bar mounting tabs are an inch thick. You will need to mark ½” down to center. Place a two by four under the sway bar. Drill…drill and drill. This may take some time. The sway bar is made out of hard spring steel. When the hole is done you can put it all together.
http://www.we-todd-did-racing.com/we...MXk1NDE%3D.jpg
http://www.we-todd-did-racing.com/we...MXk1NDE%3D.jpg
http://www.we-todd-did-racing.com/we...MXk1NDE%3D.jpg
http://www.we-todd-did-racing.com/we...MXk1NDE%3D.jpg
http://www.we-todd-did-racing.com/we...MXk1NDE%3D.jpg
http://www.we-todd-did-racing.com/we...MXk1NDE%3D.jpg
http://www.we-todd-did-racing.com/we...MXk1NDE%3D.jpg
