APS Evolution BOVs 210 Shipped and Other APS parts!!!!
KEVO8 - Your order will leave today. You should have it this week
Verano - Yes we still have some left but we are running low on stock. Next batch is expected in 2 weeks. Thanks
Ben
Verano - Yes we still have some left but we are running low on stock. Next batch is expected in 2 weeks. Thanks
Ben
Verano,
So how was the install? Is there anything I should know to make it even easier than it looks? Will I need to remove the intake air duct? It looks like that is the only piece in the way. How does it perform so far? Is there a need to adjust it, or can you just intall and go? As you can tell, mine hasn't yet been delivered, so I'm just trying to gear up for when it gets here.
So how was the install? Is there anything I should know to make it even easier than it looks? Will I need to remove the intake air duct? It looks like that is the only piece in the way. How does it perform so far? Is there a need to adjust it, or can you just intall and go? As you can tell, mine hasn't yet been delivered, so I'm just trying to gear up for when it gets here.
Originally Posted by KEVO8
Verano,
So how was the install? Is there anything I should know to make it even easier than it looks? Will I need to remove the intake air duct? It looks like that is the only piece in the way. How does it perform so far? Is there a need to adjust it, or can you just intall and go? As you can tell, mine hasn't yet been delivered, so I'm just trying to gear up for when it gets here.
So how was the install? Is there anything I should know to make it even easier than it looks? Will I need to remove the intake air duct? It looks like that is the only piece in the way. How does it perform so far? Is there a need to adjust it, or can you just intall and go? As you can tell, mine hasn't yet been delivered, so I'm just trying to gear up for when it gets here.
One thing you guys may want to check is on some valves the top adjusting nut is not tightened down all the way and can come loose over time. i would recommend tightening that down. 
Ben
Ben
To anyone who has purchased this BOV, could you post a review?
I had a bunch of problems with a Forge BOV and finally put the stocker back on. I'm looking for good driveability with no surging or fluttering. I'm running about 23-25 lbs of boost and would like to know if anyone has had any issues with this unit.
thanks,
Tony
I had a bunch of problems with a Forge BOV and finally put the stocker back on. I'm looking for good driveability with no surging or fluttering. I'm running about 23-25 lbs of boost and would like to know if anyone has had any issues with this unit.
thanks,
Tony
I just installed my APS BOV today, took about 15 minutes to get it hooked up. So far its great, no issues with it at all, just install it and go and there is no need to adjust it. Also it sounds pretty bad *** between high boost shifting.
