We are pleased to announce that we now have the Unorthodox racing pulley sets in stock ready to go! Comes in a nice bright silver color (red, blue and black will be ready early next week), this is a direct bolt on, and our kits even includes the proper belt! Dyno sheet below was for the 3 pulley set.

Price is $389.99 shipped and includes the belt - this is a 3 piece set with crank pulley, alternator, and water pump.

The crank pulley by itself is $210 shipped with the belt.

All major credit cards accepted - just call to order, as well as Paypal (and we don't charge you an extra fee!)






Adam
Z-1 Performance
631-863-3820
z1sales@z1auto.com

 

will they ever come out with a regular lancer pulley set?

 

Does this mean that the stock Mitsu belt will not fit once these pulleys are installed? Sorry if this is noob question.

 

There might be enough adjustment on the tensioner where it would fit, but we have only done it with the gates belt we supply so far.

 

 

Adam - how much would installation be on these - my hands are just to big to fit in there - maybe I will swing by and pick up a set !

 

Al - install is not too bad - takes about an hour to do.

BTW I left a message for Dan - I can ship him out a Cusco unit tomorrow if he wants, or an Exedy later on in the week - up to him (Cuscop is, as you would expect, a bit more expensive). Have him call me at the shop!

 

I had to get the cusco one cause I was without clutch ! Mine did not come with a pilot tool - and I heard the exeddy comes with one - is that right ? (some people just need to have that blue!)

I think he wants the Exeddy one - same thing really - end of week is fine as his car is apart awaiting engine

I will call you next week after my car is running to book an appointment to do the pulleys - I;d like a red set - if possible

My hands are just too big to get in that tight area

 

Red is no problem - they were out for palting today, so should have them early next week once things calm down from teh holidays.

The Exedy Hyper and Dual disk clutches do not come with alignment tools or throw out bearings - only their less expensive clutches do (aka their Sport Line, though they don't even offer these for the Evo!)....it never made sense to me either and I have made the request they change it many many times already

 

Once again, the Lancer gets screwed!

 

OK great - I'll call you on wed next week to set an appointment - keep one red set for me

I had a lovely time making up a piolt tool !!! They sure know how to torture you!

 

agreed pisetup.....we were trying to get these things made for almost a year, and then they come out for the evo in no time at all.

 

id be willing to bet if you can get a bunch of people and their money up front, one of the companies out tehre would make a set for the reg lancers, most of them dont see a market for them so they dont make em... apparently they arent looking around when they are out driving... I see like 5-10 lancers a day here in philly alone... and at least 12 on the way to NJ shore! Everyone has one!

 

 

Spoke to Unorthodox (they are local to us, and we have ben close with them for a long time now). We would need 50 people ready to commit in order to put the standard Lancer ones into production.

Adam