which coupler is the replacement for the right side of stock IC to piping (towards TB)?
do you also sell T-bolt clamps?

thanks!

 

Can I order the ones for the recirculation pipe here and if so, how wide are those anyway?

 

Running the stock intercooler with aftermarket or factory piping kits you need to use the stock black 45 degree hose. The stock intercooler outlets come down at an angle so you can't use a straight silicone coupler.

Michael

 

Are you running a stock battery uicp or a short route uicp?

 

I'm using the ETS short route uicp.

The thing that happened is that I needed to reduce the length of the silicon couplers for a better fit and I ended up cutting one of them too much and I'm worried about having an boost leak there. That's all!

 

How about black ones with no writing on them? My car is black and red all throughout and blue would stand out like a red headed step child... I installed your upper radiator pipe recently and did what you suggested - used a radiator hose, but would have loved to have black silicone couplers.


See sig below for [Engine Bay] will update with the ETS radiator pipe once I get a chance to snap a pic.

 

Yes. Good question Compscib0i.
Michael, Do you make couplers in RED? w/o logo. I need 2 for UICP. 1 to connect by turbo and 1 connection above intake Manifold.

 

We don't, only blue and black.

The writing is on one side, so you could rotate the coupler to show no logo.

Michael

 

hey i was wondering which coupler is the one that fits on the 9 turbo and a AEM intake

 

blue coupler that goes into the stock bov to 78504 pls

 

6.50 for the coupler and ground ups is 9.00

thanks!

Michael

 

pmed

 

hey pm'ed you too please get back to me asap!