Anyone have a splitter mounted to the chassis rather than the bumper cover?

 

we made a small frame mount for my splitter that is bolted to the chassis of the car.

 

If it isn't proprietary, I'd love to see pictures of the mounting set-up. I assume this is a one-off piece?

 

yea, one off.

not propritary but I dont have any pics of it... its a real simple piece, 3 welded bars that reach down to floor... i'll snap some pics next time car is off the floor.

n

 

The APR grabs the lower engine support and ties it to the chassis. I'm stretching my APR out the back with aluminum sheet to extend the flat surface under the car all the way to the bracing at the end of the downpipe.

 

i know jun makes a univ. diffuser

 

nils - please do so, as I am very interested...

 

I wish I could see the pictures

 

nils setup is definitely one of the most effective splitters I have seen on an evo.

 

Okay Nils...where are the d*mn pictures?

Has anyone felt a difference on track with the APR splitter, since it seems to be the most cost effective solution?

I'd really like to make one though. Wish there were more Evo DIY folk on corner-carvers...

 

A buddy of mine makes splitters using sheet metal..

 

I want competition associates to make the one they have on their SGT car.
Oh and Robis 3D splitter is pretty sick.
I have a few ideas that haven't been done on evos but has been done on other chassis.

 

I would but the wife took my camera with her to europe....

 

Does he have a business or sell them?

I'd hate to be a pedestrian hit by one of those metal splitters -- goodbye foot!

 

haha nah, does it out of his garage. Bunch of suby/evo guys just buy them from him. Just a lil extra cash on the side for him I guess

Here's one that my buddy Joe Simms made too. Reinforced so well, you can stand on the splitter and the whole car will tilt haha. (aluminum rods like crazy behind and below the bumper)