Official Engine Bay Picture Thread
Newbie
Joined: Dec 2006
Posts: 49
Likes: 0
From: Gold Coast, Australia
You can also use a STD EVO V or VI radiator as the rad neck is in the same position, looks like a samco hose to me.
Last edited by *WRC*; Mar 9, 2009 at 11:07 PM.
PCV valve replaced with steel braided hose tat goes to the oil catch tank.
Last edited by motoxxx55; Mar 16, 2009 at 11:42 PM.
Evolving Member
Joined: Jul 2005
Posts: 220
Likes: 0
From: Davie,FL
The RED is all wire loom over the stock wires. Costs about 30 bucks for a huge bag. It is made my a company called Taylor.
A wonderful polish is Mothers Billet polish. It's a bit expensive but well worth it.
As for cleaning the engine bay...
1. Cover your air filter with a plastic bag.
* for very dirty engines spray down the bad spots with engine degreaser*
2. Spray down the entire engine bay with Simple Green.
3. Spray the hood too with Simple Green
4. Close the hood and let the Simple Green soak while you wash the rest of the car.
5. Using high pressure, rinse out the engine bay.
6. Use a household washcloth to scrub everywhere you can reach with the soapy water from the car was solution.
7. Rinse with high pressure again.
8. Use a good shammy to dry everything all up.
9. Use Mothers Billet polish to clean up the shiny stuff.
10. Hit the rubber with silcon type spray cleaners (NO ARMOR ALL)
11. Admire your work.
Hope this helps.
Paul
A wonderful polish is Mothers Billet polish. It's a bit expensive but well worth it.
As for cleaning the engine bay...
1. Cover your air filter with a plastic bag.
* for very dirty engines spray down the bad spots with engine degreaser*
2. Spray down the entire engine bay with Simple Green.
3. Spray the hood too with Simple Green
4. Close the hood and let the Simple Green soak while you wash the rest of the car.
5. Using high pressure, rinse out the engine bay.
6. Use a household washcloth to scrub everywhere you can reach with the soapy water from the car was solution.
7. Rinse with high pressure again.
8. Use a good shammy to dry everything all up.
9. Use Mothers Billet polish to clean up the shiny stuff.
10. Hit the rubber with silcon type spray cleaners (NO ARMOR ALL)
11. Admire your work.
Hope this helps.
Paul
