I tried searching for threads about removing the interior panels for a stereo install but had no luck.

What I'm trying to do is finding out the correct way to remove the panels on the driverside. So I can have a battery wire running from engine battery to the trunk.

 

well everything pretty much just pulls right out. You just gotta put some force into it, but not brute force. Just pull, one end at a time, and everything will pop right out. As for the bottom of the B-pillar cover, its' basically just "wrapped" around the b-pillar, so you just pull it off from one side, and then it'll j/come off by itself.

For the rear seat, if you look in the bottom of the seat, there is like a pull switch thingy, if you pull it out ward, the seat will come loose (bottom half), and once you're there, you can run the wires straight into the trunk along w/the other wires that are already there (you'll see them once u get the panels/seats popped out). THen you will need to take out the trunk liner in the back side so that you can get the wires.

I hope that helps