View Poll Results: WAS THIS WORTH MY TIME TO COMPILE ALL THIS TO 1 THREAD?
HECK YEAH
906
93.21%
nope
66
6.79%
Voters: 972. You may not vote on this poll
Former Sponsor
This is all you need.
This also fits the USDM Bumper as well
GAME OVER
This also fits the USDM Bumper as well
GAME OVER
Evolving Member
i love the ARK exhaust with all my heart i wish i had 1 like mr charlie here 
Evolving Member
Quote:
This also fits the USDM Bumper as well
GAME OVER
I love the way it fits...Originally Posted by arkperformance
This is all you need.This also fits the USDM Bumper as well
GAME OVER
Evolved Member
what if my evo doesnt have the JDM rear bumper, where do i look for exhaust fitment? :S
Evolved Member
Anyone have a JDM bumper with non AMS JDM exhaust type?
Picture on 1st post aren't good.
Picture on 1st post aren't good.
Newbie
Saw the product at MOD...looks great in person...what's the db noise level witha stock catalytic?
Evolving Member
have the Ti-c on an evo 7... sticks out FAR...
Thinking of cutting the tip slightly to get a little less of that look
Thinking of cutting the tip slightly to get a little less of that look
Evolved Member
dont cut that beautiful tip! Cut the piping before the muffler and shorten it that way! I would hate to see that nice burnt ti tip get sawed off!
Evolving Member
No not the tip.. but a small piece on the inside of it just almost to the "G" in the greddy imprint...
just to take at least a 1/2 inch off the length of it...
EDIT:
Just cut the inside of the tip and it makes a drastic improvement...
I cut exactly 22mm from the inner end of the piece... now it does take a little piece off the writing... but it's very slight. You can still read "Greddy" clearly on both sides.
Then measure the position where the holes for the silencer bolt up to, drill and that's it. Simple mod. I dunno how much of a difference it will make to the JDM 9 bumper but here's the difference...
just to take at least a 1/2 inch off the length of it...
EDIT:
Just cut the inside of the tip and it makes a drastic improvement...
I cut exactly 22mm from the inner end of the piece... now it does take a little piece off the writing... but it's very slight. You can still read "Greddy" clearly on both sides.
Then measure the position where the holes for the silencer bolt up to, drill and that's it. Simple mod. I dunno how much of a difference it will make to the JDM 9 bumper but here's the difference...
Evolved Member
How did you well it back like that, look like clean welding!
Evolving Member
Quote:
That's just the reflection of the barrel itself... The Ti-C systems' tip has to be removed to get the silencer out... three screws. you can remove the tip and cut where the bolt holes are... 22mm from the end. Originally Posted by HxllxMan
How did you well it back like that, look like clean welding!
I used a hacksaw... did leave some scratches but very minor... I'm sure there is a cleaner way to perform this...
when done I had a template for the new holes to be drilled and just bolt it back to the barrel itself. I think it's a nice simple mod for any JDM iX owner who thinks it sticks out too much for their taste...
And it seems it's only the Ti-C can remove the tip... the full ti looks welded.