My JDM EVO IV
#184
Evolving Member
Thread Starter
Yeah wheels are low on my priority list right now mate but one day I will change them, I like the Gram lite 57 pro titanium ones so maybe a set of them, but as they don't make it go faster, they take a back seat
And the foggies would just get smashed where I live mate so that's why I don't have them
And the foggies would just get smashed where I live mate so that's why I don't have them
Last edited by APEX'iEvoIV; Nov 27, 2009 at 09:39 PM.
#186
Evolving Member
Thread Starter
Thanx mate, I am spending alot of time just replacing the worn out bits, will have the interior re-trimmed next, I hate that red checkered trim so will go for black velour I think, but I have to save also for a HTA Green, that will be my next and hopefully final engine mod
#187
Evolving Member
Thread Starter
Had it tuned again after finding the cat was all busted up, I had it on a different dyno this time, it made 241.2 kw and 425nm torque on 26psi without octane booster on 98 octane pump fuel, I had it compression tested and it is running 180 on all cylinders and won't take hardly any timing, 3 deg is the most under full load, so I am currently exploring my options, might go a water/meth kit or thicker head gasket.
#188
Evolving Member
Thread Starter
Well after some fine tuning with ALOT of help from Troy (BURNZY) I logged a run and ran it on the VIRTUAL DYNO ROOM in EVO -M mode and here is the result:
I am quite pleased
I am quite pleased
Last edited by APEX'iEvoIV; Mar 21, 2010 at 12:55 AM.
#192
Evolving Member
Thread Starter
been a while since I was here last, took it to the drags recently ran 11.797@118.60mph with a 1.769 60
Also we had the nationals for the Aus site I am on EvoOZ
Also we had the nationals for the Aus site I am on EvoOZ
#194
Evolving Member
Join Date: Apr 2008
Location: New Zealand
Posts: 462
Likes: 0
Received 0 Likes
on
0 Posts