3+hrs of buffing and cleaning
After a week of cleaning cars, what do I do on my 1st day off....ugh
Have not had a gararge in about 7months, so after being under trees every night it needed a good Polish.
Just started using a new swirl remover along with a foam pad which I like so far much better than the ardex products I was using before.
Always a good idea to tape off before buffing/slinging compound
1side done, still a bunch more to go
Had to put my tailgating tent up, Florida is always hot. Even at 9am
Still have to do the inside.
Have a good hand polish/paint sealent I should put on next but it has to stay on an hr, and im not sure I have the energy
from a previous clean, i like the pic though
Have not had a gararge in about 7months, so after being under trees every night it needed a good Polish.
Just started using a new swirl remover along with a foam pad which I like so far much better than the ardex products I was using before.
Always a good idea to tape off before buffing/slinging compound
1side done, still a bunch more to go
Had to put my tailgating tent up, Florida is always hot. Even at 9am
Still have to do the inside.
Have a good hand polish/paint sealent I should put on next but it has to stay on an hr, and im not sure I have the energy
from a previous clean, i like the pic though
Newbie
Joined: Mar 2008
Posts: 98
Likes: 6
From: Quakertown, PA
I have not found a polish to remove the swirls on my 1997 GSX yet. I have tried some of the Ardex stuff/lighter 3M sutff which is available in the detail department of my work. I was curious how bad the swirls were on your car and what speeds/pad combos you used? I cannot seem to find the best way without wet sanding to touch up the whole car. It is starting to look like hell.
