I was looking at shift knobs from MOMO today, and I found one I like but it is an integrated know and boot in one piece. VERY HOT...but anyway, I was wondering how easy it is to change the shift boot on the EVO. Anybody done this, or know how hard it would be? Thanks.

 

The center console pops out, there are two screws in the storage armrest and then screws down by the pedals. Then a couple clips. You need to lift out the whole section to change the boot, but after that, it's just a few screws that hold it up into the ring.

Maybe a 30 min project, not too tough.

 

momo boots are junk, stay away. And dont get a momo knob either, they fit like crap.

 

Momo boots I can't comment on, but Momo knobs, like so many others, use a hex set screw for fitment, they aren't threaded, so yes, they suck.

 

Kartboy OWNS

 

i agree, i'm all about the JDM...but this shift knob feels so good and fits perfect....a quality american made piece!

 

Cant beat the price either.