1 piece carbon fiber driveshaft
i have a few pics up in that thread(just of the shaft and the cleared bearing mounts) and yeah it did turn a little sour for some reason.i am doing a lot of stuff to the car while the motor is out so it may be be a few weeks before i get actual install pics,but i do have some pics of the work we did to clear the carrier bearing mounts.
it was actually pretty simple to remove them entirely,scratched the undercarriage up a little,but i can clean it up later with some sanpaper,primer and undercoat spray pretty easy.
to me as of now,i see no problems with fitment,there is a ton of room under there now,and i can't see why some say it won't fit.i guess we'll find out for sure when the motor gets here.
more pics in a couple weeks,also check out the nice,shiny 12-plate max-locker by TRE at the end of car.
it was actually pretty simple to remove them entirely,scratched the undercarriage up a little,but i can clean it up later with some sanpaper,primer and undercoat spray pretty easy.
to me as of now,i see no problems with fitment,there is a ton of room under there now,and i can't see why some say it won't fit.i guess we'll find out for sure when the motor gets here.
more pics in a couple weeks,also check out the nice,shiny 12-plate max-locker by TRE at the end of car.
Account Disabled
iTrader: (26)
Joined: Jul 2011
Posts: 1,784
Likes: 1
From: Clinton, NJ - Myrtle Beach, SC
