yup . looked at the installing guide post and every other one etc............My problem was Emblem was so flimsy almost impossible to keep it straight.

 

The trick was to use a piece of masking tape to keep it aligned while you peeled it and laid it down...

 

Install is super simple. You just put it too close to the Mitsu emblem. You should have pit the edge of the clear backing level with the crease in the middle of the trunk (bottom of clear backing on the crease line). I did mine today and it looks great. The finish looks the same to me but it might be because they are spaced further apart.

 

Seriously, if you cant even install a badge, you've got problems.

 

Strange LOOKS INSTALLED TO ME!! Unless you see something i dont. I am just trying to get opinion if it looks good or not. The finish is different not sure i like it.

 

 

almost scared me from getting the badge.. i agree too close to the mitsu emblem.. looks a lil offcenter/crooked might just be me.

 

Looks crooked to me too, maybr its just the picture thou...

 

not crooked, but it's not centered...will look better if you take the Mitsu symbol off...IMO

 

Its fine. I wouldn't worry about it. Its not like 99% of the other folks on the road would even know the diffference between your emblem being installed alittle high.

 

It's a little too high, but I don't see anything else wrong with the install. The "T" should be centered with the center on the .

 

looks ok to me...

shoulda been a little lower maybe...

i do like how the yellow one without the Mitsu emblem looks...

 

Whoa Chris, what kind of tailights are those, with that little white piece in it?

My JDM tails are completely red

 

They are actually Evo 8 lights with some magic... Diesel makes fun of me for them... LOL. I like them better than JDM 7's.

 

Mine's cool on Red.