Enkei RPF1 17x9.5 on Evo (confirm this plz)
May 15, 2009, 01:07 PM
#16
Evolved Member
iTrader: (5)
Join Date: Jan 2006
Location: Dirrrty Jerzey
Posts: 1,150
Likes: 0
Received 0 Likes
on
0 Posts
im running 17x9.5 38mm offset 255/40/17s
rear fits fine
front need a 20mm spacer which adds up to 18mm
i doubt the rear will fit at all without massive rolling and a small tire ...my 2 cents
rear fits fine
front need a 20mm spacer which adds up to 18mm
i doubt the rear will fit at all without massive rolling and a small tire ...my 2 cents
May 15, 2009, 01:45 PM
#18
Evolved Member
iTrader: (12)
Join Date: Jan 2006
Location: salt lake city
Posts: 888
Likes: 0
Received 0 Likes
on
0 Posts
[QUOTE=lexat20;7063611]The easiest method to use this wheel is to use a +38. A 20mm spacer is needed up from but that is it. No fender mods and you can easily run a 255 tire or a 275 with light rear fender work.
QUOTE]
+1
I run 18x9.5+38 with 20mm spacer in front on 255/35/18 (RE-01 tires)
didnt used to rub at all but the car sits REALLY low in front now and on really big bumps/dips I can hear a slight rub when the spring compresses enough and hits the fender liner, but f*** it- the look is awesome
with lowering springs and even my coilovers (before I went extra low) I had no rub except for at full lock, now the fender liner bottoms out here and there too.
QUOTE]
+1
I run 18x9.5+38 with 20mm spacer in front on 255/35/18 (RE-01 tires)
didnt used to rub at all but the car sits REALLY low in front now and on really big bumps/dips I can hear a slight rub when the spring compresses enough and hits the fender liner, but f*** it- the look is awesome
with lowering springs and even my coilovers (before I went extra low) I had no rub except for at full lock, now the fender liner bottoms out here and there too.
May 15, 2009, 06:49 PM
#20
i found them on the officaial wheel fitment thread
https://www.evolutionm.net/forums/ev...-thread-3.html
https://www.evolutionm.net/forums/ev...-thread-3.html
May 19, 2009, 07:45 AM
#25
THe name of the guy is trinydex
thread link
Page 3
https://www.evolutionm.net/forums/ev...-thread-3.html
May 16, 2010, 03:59 PM
#28
Evolved Member
iTrader: (4)
Join Date: Jun 2008
Location: Philly Burbs
Posts: 945
Likes: 0
Received 0 Likes
on
0 Posts
its too clear the brembos. I am about to throw a set of 265 direzzas on the same wheels. it is going to rub under big bumps in the front, but want as much rubber as possible. I have no experience with alcon calipers, you should measure and compare with washers and see what will fit. good luck
