BoostIt

OK, so I went to put my new rear rotors on today and the rotors currently on my car have never been replaced. I hit them with a rubber mallet and they still are not coming off....any ideas/suggestions to make sure I can put on the new ones?

Also are there any sites where there are instructions for brake pad and rotor replacement for front and rear even though it's pretty stright forward looking at it today?

Smike

iTrader: (8)

First, make sure the parking brake is off.

Second, there are 2 bolt holes, sorry, I cannot remember the size, but you put bolts in both and turn them. That will break the rotors rust.

4cdndctn

iTrader: (8)

Rad support bolts are the correct size if I recall.
This is normal, no worries.

lilman8403

iTrader: (8)

correct. i used my radiator bolts and had no problems getting the rotors off.

BoostIt

so inside those holes on the rotors I have two more bolts I have to undo????

AWDPowah

iTrader: (21)

I'm suprised you're having problems with a 2005. Mine come off easy as soon as i remove the caliper.

The 2 holes can be seen here:

You put the bolts in there and keep turning until it breaks loose.

huevosrancheros

iTrader: (14)

Or you could wack it with a sledge hammer, that'll pop them off. Screw your going to replace them anyways, lol