Drag setup
#1
Evolving Member
Thread Starter
iTrader: (29)
Join Date: Jul 2008
Location: NY
Posts: 190
Likes: 0
Received 0 Likes
on
0 Posts
Drag setup
I already picked up a set of wilwood front brakes and im thinking of picking up a set for the rear but I don't know if its really going to be worth the 1k.
I think that Im going to be running QTP's but im not sure how tall/wide I should go and should I run a 15" wheel so later I can go with full slicks. Ill be running stock gearing in the trans.
Any suggestions?
Also I trying to decide on a set of wheels, something lightweight and cheap that dont look to horrible, Im leaning towards a set of rotta's. What is everyone else running, size/offset?
I think that Im going to be running QTP's but im not sure how tall/wide I should go and should I run a 15" wheel so later I can go with full slicks. Ill be running stock gearing in the trans.
Any suggestions?
Also I trying to decide on a set of wheels, something lightweight and cheap that dont look to horrible, Im leaning towards a set of rotta's. What is everyone else running, size/offset?
Last edited by jmtx86; Aug 12, 2010 at 05:34 PM.
#3
Evolving Member
Thread Starter
iTrader: (29)
Join Date: Jul 2008
Location: NY
Posts: 190
Likes: 0
Received 0 Likes
on
0 Posts
Its basically setup for drag racing/weekend driving. The reason I swapped the front brakes was to save a lil on the rotating weight. I may end up just going with fd wheels but I think I prefer something else.
#4
Evolving Member
iTrader: (58)
Join Date: Jan 2009
Location: Milwaukee
Posts: 137
Likes: 0
Received 0 Likes
on
0 Posts
well here's some rear wilwood brakes for sale, save you a few hundred
https://www.evolutionm.net/forums/sa...es-tilton.html
https://www.evolutionm.net/forums/sa...es-tilton.html
Thread
Thread Starter
Forum
Replies
Last Post