Niks EF3x @ CBRD..
Thread Starter
Newbie
Joined: May 2011
Posts: 58
Likes: 0
From: Pelham bay, ny
Niks EF3x @ CBRD..
Had a really good experience at CBRD, Chad most def knows evos in and out and explains everything you need to know thoroughly. picked the car up from the shop about a week ago and it feels like a complete different car. the cars a monster! Also would like to thank MAP because Chad said the ef3 really performed well on the mustang dyno as you could tell from the dyno sheet.
2011 EVO GSR OCTANE BLUE 12k miles
MOD LIST
MAPS EF3x (Antisurge,Ported,Coated)
AMS fmic
AMS upper and lower intercooler pipes w/ Tial QR
AMS intake
AMS widemouth downpipe
AMS Testpipe
Tomei catback
FULL RACE prostock manifold titanium coated
I.D 1000cc
KOYO radiator
GrimSpeed bcs
Defi Boost
AEM air/fuel
STOCK ENGINE
STOCK CLUTCH
STOCK FUEL PUMP
Car Made 413whp and 333trq on 93octane at 26.2psi on a low reading Mustang dyno
stock pump is fine at these power levels-
we have had more issues with aftermarket pump assemblies!
the motor will be built shortly and then boost goes up, setup will go up with it!
I did like this turbo- slightly slower spool than our lite, similar power-
cb
we have had more issues with aftermarket pump assemblies!
the motor will be built shortly and then boost goes up, setup will go up with it!
I did like this turbo- slightly slower spool than our lite, similar power-
cb
Thread Starter
Newbie
Joined: May 2011
Posts: 58
Likes: 0
From: Pelham bay, ny
Thanks! and yea Chad said it would be good on the stock pump until i do my build and its been holding well i drove 3 and a half hours back from CBRD really getting on the car and everything is still smoothe
Ill be back shortly Chad!
Ill be back shortly Chad!
Trending Topics
Evolving Member
Joined: Mar 2005
Posts: 486
Likes: 0
From: 900 pounds lighter than a X.
[QUOTE=xratedevo;10039261]Thanks! and yea Chad said it would be good on the stock pump until i do my build and its been holding well i drove 3 and a half hours back from CBRD really getting on the car and everything is still smoothe
Ill be back shortly Chad
Thread Starter
Newbie
Joined: May 2011
Posts: 58
Likes: 0
From: Pelham bay, ny
[QUOTE=U2SLO;10039298]no im in the bronx ny
Evolving Member
Joined: Mar 2005
Posts: 486
Likes: 0
From: 900 pounds lighter than a X.
Thread Starter
Newbie
Joined: May 2011
Posts: 58
Likes: 0
From: Pelham bay, ny
[QUOTE=U2SLO;10039419]thanks! and yea i seen it there! pm me your number when you get it back we should def do that im right over the whitestone bridge !
