Efr 9180c iwg 823whp 558tq

Reply Subscribe

Thread Tools

Search this Thread

Nov 23, 2015, 05:14 PM

#46

black E

Evolved Member

Thread Starter

iTrader: (77)

Join Date: Mar 2007

Location: Boca Raton FL

Posts: 512

Likes: 70

Received 33 Likes on 17 Posts

Exedy triple

Reply Like

Nov 27, 2015, 10:12 AM

#47

erickponce

Evolving Member

iTrader: (2)

Join Date: Jan 2006

Location: Ogden UT

Posts: 106

Likes: 0

Received 0 Likes on 0 Posts

Hey black E, how well did the dual port WGA work compared to the single port?

Reply Like

Nov 27, 2015, 02:12 PM

#48

black E

Evolved Member

Thread Starter

iTrader: (77)

Join Date: Mar 2007

Location: Boca Raton FL

Posts: 512

Likes: 70

Received 33 Likes on 17 Posts

Is def better but it's not worlds better. It leaks a little out the shaft hole so I'm sure if it didn't it would be a lot better.
At the end, I can get 42psi at 9k rpm on my setup so it's enough to get the job done.

Reply Like

Nov 27, 2015, 02:47 PM

#49

erickponce

Evolving Member

iTrader: (2)

Join Date: Jan 2006

Location: Ogden UT

Posts: 106

Likes: 0

Received 0 Likes on 0 Posts

Is it possible that it could have been defective?

Reply Like

Nov 27, 2015, 03:57 PM

#50

black E

Evolved Member

Thread Starter

iTrader: (77)

Join Date: Mar 2007

Location: Boca Raton FL

Posts: 512

Likes: 70

Received 33 Likes on 17 Posts

I've worked with a few and so far they all leak to some extent. You can take it apart and seal it better but over a short time it starts leaking again. It's just a bad design as the rod has to move in and out of the lower chamber.

Reply Like