I got my clutch swapped out today and as I am driving home, the service engine soon light comes on with a picture of like the drivetrain in the informeter. I bought it used so there wasnt an owners manual with the car. Any thoughts??

 

Pull the code?

 

+1 go back to the shop and have them pull the code.

 

they are all closed over here. Has anyone heard of a flywheel being to light and throwing a code bc of it?? I think I remember reading it somewhere

 

I think Fidanza said that a light flywheel might throw a code.

 

it prob is not a check engine light it is prob the awc service required light cycle the ignition and it should go out

i had this problem after my clutch install also. It seems that when i had my car tuned the clutch must have been slipping a bit and the new clucth cause me a world of issues tell i got retuned

 

i turned it off and on again and it went away, but then after i drive it for a while it will come back on. but my alignment is off so i think that is what is setting it off. Im getting an alignment today so I'll let you know.

 

Its your flywheel. Its too light. My friends maxima had identical issues!

 

I have seen reports of a light flywheel throwing codes on the X as well. let us know what you figure out.

Michael

 

i have to take it in to the dealership next week so they can pull the codes, will post up results from that.

on a side not it doesnt drive any different(nothing lacking engine wise) the only thing is that the fun to watch AWC screen doesnt work and it wont let me change settings(tarmac, gravel, snow)

 

Any news?

 

not yet been getting taxed out at work so far, hopefully sometime this week though.

 

keep us posted..

 

the computer is taking over ...

 

will hopefully get results on Mon or Tues for those who want to know beside myself