Wastegate Actuator pretension when using a 3-port
Thread Starter
Evolving Member
Joined: Aug 2004
Posts: 142
Likes: 0
From: Germany
Wastegate Actuator pretension when using a 3-port
Hey guys! About to receive my Grimmspeed 3-port.
How much pretension (if any?) should I be putting on the wga? My target boost is around the 26psi/1.8bar mark...
I got a pretty good understanding on how to retune my map to account for the 3-port, but I couldn't find any info on how it will affect the pretension.
Stock tension should be around 4 full turns less than fully closed? (bought the car tuned, so I don't know the stock setting)
How much pretension (if any?) should I be putting on the wga? My target boost is around the 26psi/1.8bar mark...
I got a pretty good understanding on how to retune my map to account for the 3-port, but I couldn't find any info on how it will affect the pretension.
Stock tension should be around 4 full turns less than fully closed? (bought the car tuned, so I don't know the stock setting)
Thread
Thread Starter
Forum
Replies
Last Post
Kmonami
04-06 Ralliart Engine/Drivetrain
4
Apr 4, 2015 02:24 PM
Kracka
Evo X Dyno Results
295
Oct 3, 2012 03:03 PM
