Hello All,

This is a little write up for the Cusco EVO X specific Catch can. I didnt know what
to expect when I ordered it and didnt know where it would go. No one has this one advertised and I didn't know it was available.


Here are the parts it comes with:

 

I didnt like the clear hose that it comes with so I went with some Russell Pro Classic Hose Part #632073 for 10"
(the clear hose that comes with it isnt enough to recirculate to the intake)

 

1. This the bracket your going to replace with the cusco one.

2. Installed

3. Here is the Catch can bracket installed/This wiring harness needs to be pushed out of the way so I tightened it down with some zipties.

4. Can Installed and you can see how much room you have left.

 

Here is how I routed the hose. I cut it a little long so when I change over to AN fittings I will have some extra.

Last one is my work in progress engine bay.

Hope this helps answer some questions.

Cheers,

 

nice! my order should be in next week can't wait till i install mine

 

install looks amazing! any chance you could post a pic or two on where you hoked up the other ends of the hoses? thank you

 

the pcv is actually on the pass lower side of the valve cover, you re-routed the breather hoses.

 

Ya, I like the black hoses way better. Looks like a nice piece. Where did you order it from?

 

this fits with stock airbox/aem cai?

 

that's a long route for the hose which can affect the suction with the intake pipe connection.

 

Uploaded with ImageShack.us

i mount it behind the intake i couldnt find other place

 

looking nice.

~Sean

 

[IMG][/IMG]

[IMG][/IMG]

 

That looks great!

 

i say again, all you guys are bypassing the breather hose, pcv is on the other side. please double check your work.