Hi All,

I might be on the wrong area but I put my lip on the other day but my box was torn so I had to find the right clips/speed nut to put on there. My issue is that when I measure the distance from the inside edge of the lip to the screw hole it is 1inch. The clip I has the hole measured at about 1/2 to 3/4 mark so when I line it up there is a 1/4 inch differences. I asked a few members on Evo X forum about this too but wanted to see if any of you here had issues installing it. So far it is on the car and the picture is below but I want to make sure I put the speed nuts on before I start driving it again to be on the safe side.

 

seems odd to me

 

I got it all figured out. With the help of another forum member, I went to Lowes to by M4 screws and figured out where the clip is supposed to go to.