yes they are, 19 x 10s in burning black chrome. The car is actually pretty dirty, just rolled and pulled the fenders, lowered it, and got an alignment. I plan on washing and waxing the car and the wheels this weekend to do a quick photo shoot.

 

Nice. They look good on the X

 

Thanks, I'm pretty happy with how everything turned out.

 

 

Swift Sport Spec-R Springs (for now...)
18x9.5 +20 Work Emotion Kiwamis
265/35/R18 Bridestone Potenza RE-11s
Rear fenders rolled and pulled slightly (Yes, they did rub quite a bit)
Front fenders untouched but do rub plastic liner at full turn

 

 

sick shot

 

love the black editions.
must sell my re30s to get a set though

 

Hey guys, I know this isn't a "request a photo" thread but the photo I'm requesting does fit with the thread. I figure this was a better place to request it. I'm stuck between two size tires since my stock 245 are almost goners. It's tough because I can't just "try on tires" and it's tough finding somebody with my exact setup. So if anybody with this setup or something equal to it wouldn't mind posting a few photos of their cars I would greatly appreciate it. I have xxr 227 18 X 9.75. I'm considering the Hankook rs3 265/35 or 275/35. I have GTworx springs. Just curious to see some photos with those wheel widths/offset and tire sizes on an Evo X to see how they fit and how far if any they stick out past the top of the fender/qtr panel edge.

Believe me, I went through all 100 pages plus of this thread and if the photo existed I missed it due to computer screen fatigue!

Thanks again and this will make my life so much easier before ordering tires in the next few weeks.

Thanks a lot

 

may want to post your offset so we can tell u if your wheel would be past the fender. Even if you have a +15 offset, it would b close, but not past the fender. As far as tires. I have a 255 on a 10" and they're barely stretched. i wouldnt go larger than that 265.

 

265 should fit a 9.75 best. I run 255 on 9.5 and it's fairly square, definitely not stretched.

 

255mm=10" So any more than that it wont be a stretch, it'd b a buldge

 

^ LOVE the Set up man!

 

Crap. I posted the offset then deleted it when correcting something. They are +20

Thanks.

 

That looks great!