Just installed my wind splitter from APR. Looks subtle but still aggressive... Flame on!!!

 

nice , I like!

 

berry nice !

 

nice! i like....can we get a shot of the front from farther back and a lower angle!

 

Looks great

 

red mitsu emblem looks horrible...splitter looks great

 

I've been looking at getting one of these, a few questions:

Do you have take the front bumper cover off to install or were you installing other
parts as well?

what happens to the stock plastic undercover? Looks like it replaces it, sort of.

do you have make holes or otherwise alter/cut the lower grill for the the support
strut rods?

 

Is that a custom made pc ?

 

Like the black/white 2 tier combo on apexi

 

That looks nice!

Two questions:

Did you have any problems installing it since you have the aero kit? I have the aero kit and would like to get it if it wasn't a pain in the *** to put on.

What brand is your Carbon Fiber Center Bumper Cover? Any fitment issues?

Thanks

 

you'll have to take off the front bumper, the cover stays in place.

stock plastic undercover was left behind in a parking lot down in ft. lauderdale. damn concrete stoppers... but yeah, it replaces the under tray.

drill holes in the wind splitter and in the front bumper, each side of the intercooler

 

i removed the rubber lip before installing. maybe you can trim the lip a little so it will fit with the wind splitter. fairly easy to install actually, i would recomend to have a person with you to hold the front bumper when taking it off and putting it back on. i did it all by my self tho...

carbon fiber bumper cover was from evo-r.net. its high quality CF and i haven't had any issues so far.

 

i'll take some more pictures tomorrow

 

Looks good, I like.

 

i like it, nothing too wild. i might try and remove the APR sticker though.