I have a 03 evo 8. The mods are tbe,aem intake,hallman mbc,ported exaust manifold,fuel pump,fuel rail,injectors,272 buddy club cams, gredddy cam gears,act heavy duty clutch and street light fly wheel,custume tune. So what next i was thinking intercooler and pipes or turbo. Which should i do first?? Thanks

 

10.5 hotside, and o2 housing

 

And at least lower intercooler pipe

 

Dick (but valid) answer: Driver mod; go learn to drive what you have.

Nice answer: Try some suspension mods, that way you'll be able to put the extra power down to the ground a little better.

 

search button helps too, Its that little thingie right above and next to new posts Oh and welcome! nice introduction (boys)

 

I like this!

10.5 hotside, Lower IP, 02 Housing will all help power. Beyond that, you could get a tune for meth and/or race gas.

Suspension and brakes probably need addressed. Some springs or cheap version coilovers.

Possibly rims/tires if you wanna change the looks. But it's all personal preference.

 

the 10.5 hotside and the 02 is a good idea too....i would say its time for some alky...then and intercooler and piping. that intercooler is ok for like 400whp. then i would deffinatly change it.

 

Thanks for all the input the best has to be driver mod. But ur right about that. What is the 10.5 hot side i know what a 02 is. Sorry for being a newbie with the questions.

 

It's the side of the turbo where the exhaust gases enter and exit. The other side is the intake side that routes to the intercooler. Technically one side is the compressor and one side is the turbine (hotside).

 

So i should not up grade the tubro just the 10.5 hot side and the 02. Would this not be a waste of money if i am going to upgrade to a biger turbo. I am trying for 450 whp. i am curently at 316whp. i am instailing injectors and fuel rail this weekend. I still have my stock cat too. Thanks for all the input so far

 

Just answering a question. If you're going to get a turbo kit, you'll get a whole new setup with a downpipe (assuming you get a quality kit).

 

I was not going to get the kit just the turbo was thinking a 50trim or a 20g. Do i have to get the hole kit or can i just get the turbo.

 

intercooler , ic pipeing and a tune!