So I already searched and I can't find my answer...
Ok, so I'm installing my Greddy EBC and I disconnect the stock boost line from the actuator. The instructions tell you to connect a 6mm hose (supplied) to the actuator and the to the new valve unit. Problem is the 6mm hose slides on and of the actuator even with the clamp.... what do i do?

 

try zip ties and hair spray

 

Anyone whos installed this.... What did you do???

 

Go to autozone & get a smaller hose, like a 4mm, or a 5mm. Sucks but you gotta do what you gotta do.

 

Use a 4mm and force it on to the 6mm nipple on the controller. Zip tie it as well on the LICP and WG though.