I jumped the gun in ordering the last available Trust exhaust from a vendor on here. It is a Japan spec exhaust, cat-back. Well After Searching for an 'exhaust install' help guide because I was going to do the work myself, I found out about the little sensor I think it is called the o2 one in the back half of the exhaust system on stock evo exhausts.

See the circled part of the picture attached. Note: The exhaust on the left is NOT mine, it's just a picture I copied from another user.

When a friend lifted his evo today he had a greddy exhaust and it had the sensor inlet built in to it. I believe that's the (mid?) pipe? Well when my exhaust came i inspected it and noticed there is no inlet for these cables.

Wondering if anyone has a solution or has encountered this before.

 

take it to the mufler shop and have them weld it for you...good luck

 

muffler shop or you could plug the o2 sensor into the test pipe if there is a bung there