Been back and forth on what to do next to my evo. I was wanting to get some opinions.
Current Mods:
HKS BOV
Bushur Down Pipe
HKS Test Pipe
Buddy Club Cat Back
Excedy Hypyer Single Clutch
F&R Perrin Sway bars w/ end links
Perrin Intake
Slotted Rotors
A few things I want to do
Replace the front lip (it's cracked)
Replace Vortex Generator to cover scratches from when it ripped off
Upper and lower IC piping

That's where I am at so far....I'm wanting to add a few things and then go get the car tuned next summer but I'm not sure where to go from here. I'm wanting to hit 350-375whp with a safe tune.

 

http://www.4wstuning.com
OR
A PM to 4WSTuning

 

Could I hit the horsepower tuned on my set up?

 

I don't think so with your mods exhaust and intake isn't much. maybe 290-300hp

If I were you I'd read the how to mod your evo sticky at the top of the this forum.
https://www.evolutionm.net/forums/ev...g-dummies.html

 

if i were you i would get rid of the HKS bov and get a synapse!! good place to start!

 

evo 7 tailights!!!

 

^^^ yeah that will make you go FAST

 

1 - finish up your airflow(upper/lower IC piping, intake, ported exhaust/intake manifolds, 02 housing, tbe, etc)
1.5 - tune
2 - fuel pump/injectors
2.5 - tune
3 - camshafts/springs/retainers etc..also could get some headwork done too if you can afford it at the time
3.5 - tune

if you can't get tuneed in between each mod(i sure can't afford it) then jusst keep buying and saving all the parts and do it al at once.

this should get him to 350-375 awhp right??? maybe more with headwork/intake mani/tbe right?

 

yeah he would be above that, with all that porting for sure!! but even without that... a good set of cams, walboro and lower IC, and TBE should get you to that point!!!

key word is GOOD cams!!