What is going on with my cluth pedal? when i press the pedal down it seems, its does come into contact till the very bottom? is the clutch going out? or what PLEASE HELP

 

Bump

 

sounds like u need clutch pedal adjustment

 

How do you do that?

 

look at the pedal assembly..there is a nut on a rod that goes through the pedal..you just thread the nut up or down to adjust. very easy takes 4 minutes

 

http://www.evomoto.com/tech_articles..._article_id=28

 

The pedal is where its supposed to be. Its like there isnt any force behind the pedal. Like i have to press it all the way to the floor for it to engage.

 

And this morning i started it up. tried to put it into gear. And it wouldnt move to first. this is a disappointmentPlease advise

 

How many miles on the clutch? Seems like the clutch is going out. Is it slipping?

 

I'd check the slave cylinder (have a buddy watch the slave cylinder as you push the clutch in and let the clutch out, it should move about 1.25").

If the slave cylinder doesn't move - you can try bleeding the clutch line to ensure there is no air in the line and then try pushing the clutch in/out again.

If that doesn't help it could mean the slave cylinder is shot (roughly 50$~) or it could be a bad master cylinder.


Those would be the steps I'd take to troubleshoot it.


-Bink

 

Did you try adjusting the pedal out? If not do so.

If this still does not work I would last resort try bleeding out the slave. Then after that it is time to drop the tranny and take a look


EDIT: LOL Bink beat me to it

 

Sounds like u hava leak in ur clutch line someplace