I am in the market for an oil catch can but there are too many. It will be used in an evo 8. There are catch cans that have a breather filter then there are ones that don't. There are generic catch cans on eBay for $25 then there's catch cans for over $200. Any recommendations?

 

depends on what you need it for,if you have excess crankcase pressure then i would recommend one of these so you can vent the VC into the can and the can into the air inlet.

http://www.jcsautomation.com/vs%20catch%20cans.html

if you just want one for looks,then get whichever one you like the looks of.

i have a Boomba can for sale with a breather for $60 in the for sale section.it's a nice,clean looking,almost new can that has lines that will fit stock size VC outlet.i am having my VC drilled and tapped for 1/2" size lines and getting one of the cans above b/c i am making big boost.

 

i am selling both of my custom catch cans. here is a thread i made for them when i had them built if your interested. there not cheep but you pay for the best and there actual function.

https://www.evolutionm.net/forums/ve...ans-mpfab.html

the box one i am selling and the valve cover is going with it. i will need a good valve cover back though. i am asking 300.00 for the hole setup.

the back one i am asking 150.00 for it.

any questions PM me

 

http://www.saikoumichi.com/

I have the dual catch can setup

 

This, I have the same set. Cheaper catch cans are going to clog the filter and spew oil vapor in the engine bay while ones that route back into the intake will coat the entire intake system with oil and vapor.

 

Check out the how to make an oil catch can thread

There's a great write up. It only costs around $25 and it'll be better quality than anything you buy