Something has to be wrong here. It doesn't look right.
 

I was inspecting my engine just because I'm so curious and I find this ****... :mad:
What the hell the screw is not screwed in right. Is it suppose to be like that. Here check it out. This is on my month old evo iX.


http://i2.photobucket.com/albums/y34...7/IMG_0047.jpg

:eek: I am truly speechless.

Is this a serious post?

Just shut the hood and don't open it again.

Judging from the picture it looks like that may be a bolt holding on a clamp. It's not screwed in anymore because it didn't need to be, the clamp is tight enough. Where is this bolt in the engine bay, the picture is very close. I can check my IX out and see if it's the same.

OK; I'll bite. It's the adjustment screw on a hose clamp. They look like that, even when tight.

:lol: actually go and return it

That's a good point, if you see something that bothers you, don't look at it.

Also,

If something is making noise, turn up the radio so you can't hear it.

That clamp holds the MAF pipe onto the turbo. The screw tightens down until it's tight enough to hold the clamp in place. What's the problem?

umm im confused here whats the deal? i think mine looked like that before i put my intake on?

I'd personally change the muffler bearings and check the turn signal fluid.

Looks like the boldt clamp on the intake tube to the turbo mine looks like that on my 03 it still tight

lol there's nothing wrong

Just put a wrench on it, if its tight then your golden. Remeber righty tighty lefty loosie!

I recommend a 10mm socket w/ratchet for ease, but I'm sure it's already tight.