I had a question about mailing in reflash. I wanted to know where you guys went and all the details on the best place to go. I also was wondering if when you guys mail them in what do you have to do to put them back in the car. Do you have to take it to mitsu or what? Not a clue and i searched around but never found any specific answers. Thanks for you help.

Zach

 

Send it to DynoFlash.....Just take the plugs out and send the ecu. When you get it back, just plug eveything back in...

 

All you have to do is take out your glove box, unbolt 4 screws and unplug ur ecu and your done. It takes 5 min. to do. I wouldnt take it do the dealer, just do it in your garage. Mail your ECU, wait for it to come back and reinstall it. When you ship it out list off all the mods you have on your car and what octane you run ur car and and we'd flash it accordingly. Me working at Vishnu, would recommend a Vishnu Flash, (i'm a little bias). =)

 

On the contact page at www.dynoflash.com there is some instructions and in the dyno flash vendor section there is a stcikey thread on ecu removal

 

Thanks for all the help, I am an auto tech at gm and know that if you take a ecu out we have to reprogram with a tech2 and did not know if it would be the same for mitsu. thank you for all you help

Zach

 

No need to get the dealer involved. The only time you would need to is if you wer using a ECU from a different EVO. They would have to flash it for the immoblizer.

 

If you prefer an EcuTek reflash let us know. We can do mail in flashes for your specific mods. Of course a custom dyno tune is much more efficient and powerful.

Nick
Precision Dyno

 

In the small town of springfield mo it would cost to much to go to get a full custom dyno tune i would believe. This is why i was looking at the mail in flashes.

 

This is why I also asked if you wanted to go with a mail in from EcuTek.