1st thing: I can't read wideband AFR, the only thing I can get it to read is voltage.

2nd Thing: It won't let me clear codes or even view codes, it just says no information available.

Some things though. I didn't follow the directions completely. I didn't clear codes prior to installing the new firmware because I hadn't swapped the jumper over yet, I was busy, and getting my buddy with a laptop to help me took me a while, I had to go to his house and it was too cold to swap the jumper in his driveway.

I figured I would be able to clear the codes.

 

I can't read wideband on my palm pilot either for some reason. I can on the laptop however.

I haven't installed the obd2 update yet though.

 

I plug mine into the ecu+ and it shuts the palm off!

 

finding a laptop it is!