OK guys i have done a little digging around already but i haven't come up with any answers, i just finished purchasing the parts that i need to install my SAFCII and my Greddy Profec E-01 boost controller, and i need help tuning it a little and i have a couple questions before i start anything....
DO i need to worry about timing?
Do i need to get an Air/fuel ratio meter at this time?( most likely yes, right?)
If yes where can i get a cheap one fast?
What kind of boost can i run on my current set up...?
what Kind of correction should i be running with that boost?

Those are pretty much all my questions those far until i get into tunning it later... I would just go get it tuned but money ran short, so i was looking for some general advise that i could do my self, with out blowing anything up, hahahah .... if there is a topic already let me know, i can read too hahhaha

 

Bump!!

 

bump, any one have any input?????

 

come on... doesn't any one know anything?

 

I have my PLX-R500 for sale. Will give you the wideband AFR readings that you desire. Best unit on the market.

 

Anyone Have Any Input, I Also Had A Little Trouble Setting The Boost To A Moderate Level........ Does Anyone Use This System??