is there any way to send a signal to my ecu+ to log from my aem ugeo wideband. right now it is just setup in the dp with a power soruce and hooked up to the gauge.

 

Read the manual, there is a connection for the eugo to the ecu+ to log.

Seriously though, read the manual.

 

^Bingo, it's in the manuals. But there is a 0-5v output on the Uego gauge, run that to the correct ECU+ input. Setup the ECU+ software to AEM guage uego and you're done. Logging AFR like the best of them.

Ivan

 

just a quick question, on the ecu+ manual it says to use the blue wire in group c for the signal for the wideband. im assuming that the blue wire is the only blue wire that has nothing connected to it coming out of the ecu+. am i right with this assumption?

 

You are correct sir.

Tom